Owners manual

- 11 -

Installation

The installation of the H15 consists of the following steps:

1. Making Connections

2. Applying Power

3. Setting Up the H15

Making Connections

Note: Whenever the H15 is plugged into a utility AC power source, the

microprocessor is active and the unit monitors the input power (standby

mode).

Prior to connecting equipment to the H15 Power Conditioner, ensure the

unit is functional by connecting the AC Power Cord (provided) at the rear

panel ( , Figure 3). Once power is applied to the unit, the display pro-

vides the following messages:

• If the unit was in the ON state before the AC input went off, the unit

will automatically turn on the outlets again when the input power is

restored. The display menu will also be restored.

• If the unit was in the STANDBY state before the AC input went off, the

unit will remain in the STANDBY state and there will be no LED or

LCD display.

Note: Due to the unique filtering and surge protection provided by the

H15, APC recommends connecting AV components as noted on the rear

panel of the unit (Figure 3).

Connect your AV components as noted on the rear panel, and as defined in

the section “REAR PANEL CONNECTORS”. To ensure ground loops are

eliminated, thus eliminating an audible hum through your speaker system,

ground all AV components to the Ground System terminal located on the

rear panel of the unit ( , Figure 3).