Owners manual

- 12 -

Applying Power

Apply power to the H15 by pressing the front panel Power Switch ( ,

Figure 1) fully inward, then releasing the switch. Once power is applied to

the unit, the display shown in Figure 4 is illuminated.

Figure 4. Voltage In/Voltage Out Display.

Note: In the display shown in Figure 4, the input and output voltages are

the same. (The actual voltage may vary depending on the power supplied

by your utility.) In this case, both voltages are within acceptable ranges,

thus, the H15 does not have to “clean up” the output voltage.

Setting Up the H15

Using the front panel Setup and Select push buttons ( and in

Figure 1) you can configure various functions provided by the H15 (Dim-

mer, AVR Range, Delay Time, Beeper, or Language (English, French, or

Spanish)), as defined in the following paragraphs:

Dimmer Function — Allows you to set a brightness level for the Backlit

Display, as well as the LEDs (Off, Dim 3, Dim 2, Dim 1, Normal, Bright 1,

Bright 2, Bright 3). By pressing the Setup push button once, the display

shown in Figure 5 is illuminated. Once the display is shown, repeatedly

pressing the Select push button allows you to set the brightness of the dis-

play. Once the Display brightness is at the desired value, press the Setup

push button to store that setting.

Figure 5. Dimmer Display

Vin = 121 Vac

Vout = 121 Vac

SET DIMMER ?