Instructions / Assembly

Conbraco Industries, Inc.
Matthews, NC 28105
1.888.229.2874
www.apolloflow.com
is-manifolds_04/05/17
INSTRUCTION SHEET
PEX Manifold Systems
Warnings
PEX
• Before and after installation, ensure manifold is kept in a location with limited exposure to chemicals, paint, hazardous materials, debris, excessive
heat, direct flame, or moving objects that could cause damage.
• The manifold should be located in an area that will not be covered permanently with sheetrock, plywood, or paneling.
• Manifold should not be installed or kept in a location exposed to freezing temperatures.
• Care should be taken not to over or under tighten fittings.
• Distribution lines must connect to the connecting valves in a straight line perpendicular to the manifold as to avoid bending stress on the valves.
• Manifolds should be installed per all local and national building/plumbing codes. Where a conflict exists between installation instructions and
local requirements, the local codes shall take precedence.
• The installer must also meet all qualifications required by the state and/or local administrative authority administering the provisions of the code
where PEX piping is installed.
• Apollo is not responsible for leaks and property damage caused by failure to follow the installation instructions.
Each manifold has a galvanized back plate for easy mounting to any structure. The cover plate, for labeling purposes, is constructed of 1/4" ABS. All manifolds are fastened to the
back plate.
Each manifold consists of two inlet ports that supply the dual chambers. Typically one inlet is used for cold water supply, and the other inlet is used for hot water supply.
However, both inlets may be used for either hot or cold water. The inlets are not temperature specific. The water inlet connections are 1" MPT or included 3/4" PEX x 1" MPT
adapters can be used to make the inlets 3/4” PEX Barb. The outlets are 1/2" MPT. 1/2" FPT Swivel x Barb valves are included.
Each manifold includes red and blue labels for indicating the destination fixtures.
Additional Information: