Instructions / Assembly
Matthews, NC 28105
www.apolloow.com
69PTKH-I_12/1/11
69PTKH00143; 69PTKH00144;69PTKH00185
69PTKH0014C; 69PTKH0015K
PEX Crimp Tool
How to use:
1
2
3
4
1
For 69PTKH0015K
To remove and replace crimp heads:
1. Cut tubing end squarely.
Check for and remove any
burrs.
2. Slide crimp ring over end
of tubing. Insert tting into
end of tubing until it stops.
Position the crimp ring
1/8" to 1/4" from the end
of the tubing and over the
ribs of the tting.
3. Place the crimping end of
tool around the crimp ring
and press the handles
together.
4. Check for proper crimp
with the Go/ No-Go
gauge.
1. With the handles.
fully open, press
side release spring
upward until the
hook is above the
jaw pin.
3. With the side
release spring
pressed upward,
slide new jaw into
place and release
the spring.
2. Slide jaw out of
position and
remove.
2 3