SDS

Page 4 of 7
Report No.：CCJC2019A3724-1
深圳诚测检测技术有限公司
Shenzhen CCJC Technology Co., Ltd
Tel: [phone] Http: //www.ccjctek.com Email: [e-mail]
Add: 1st Floor, Xinbaoyi Industry and Trade Building B, Houting Community, Shajing
Town, Bao'an District, Shenzhen City, Guangdong China
areas. Keep people away from and upwind of spill/leak. Refer to
protective measures listed in Sections 7 and 8.
Environmental Precautions
Prevent product from contaminating soil and from entering sewers
or waterways.
Methods and materials for
Containment
Stop the leak if safe to do so. Contain the spilled liquid with dry
sand or earth. Clean up spills immediately.
Methods and materials for
cleaning up
Absorb spilled material with an inert absorbent (dry sand or earth).
Scoop contaminated absorbent into an acceptable waste container.
Collect all contaminated absorbent and dispose of according to
directions in Section 13. Scrub the area with detergent and water;
collect all contaminated wash water for proper disposal.
Section 7 - Handling and Storage
Handling
In case of rupture. Handle in accordance with good industrial hygiene and
safety practice. Avoid contact with skin, eyes or clothing. Use personal
protection equipment.
Storage
Store in a cool, dry, well-ventilated area away from incompatible
substances. Store locked up. Keep out of the reach of children.
Other Precautions
The battery may explode or cause burns, if disassembled, crushed or
exposed to fire or high temperatures. Do not short or install with incorrect
polarity.
Section 8 - Exposure Controls/Personal Protection
Engineering Controls
Use adequate ventilation to keep airborne concentrations low. If used
under conditions that generate particulates, the ACGIH TLV-TWA of
3mg/m
3
respirable fraction (10mg/m
3
total) should be observed.
Personal Protective
Equipment
Eye and Face Protection: None required for consumer use. If there is a risk
of contact: Tight sealing safety goggles. Face protection shield. Skin and
Body Protection: None required for consumer use. If there is a risk of
contact: Wear protective gloves and protective clothing. Respiratory
Protection: No protective equipment is needed under normal use
conditions. If exposure limits are exceeded or irritation is experienced,
ventilation and evacuation may be required.
Physical State
Appearance: Cylindrical
Color: Green
Odour: If leaking, smells of medical ether.
Section 9 - Physical and Chemical Properties