Declaration of Conformity

Apple Watch Magnetic Charging Cable
Certification and Compliance
Australia
New Zealand
U.S.
Japan
Korea
R-R-APL-A2255
FCC Compliance
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation.
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment to an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications to this product not
authorized by Apple could void the electromagnetic
compatibility (EMC) and wireless compliance and
negate your authority to operate the product.
This product has demonstrated EMC compliance
under conditions that included the use of compliant
peripheral devices and shielded cables between
system components. It is important that you
use compliant peripheral devices and shielded
cables between system components to reduce
the possibility of causing interference to radios,
televisions, and other electronic devices.
Responsible party (contact for FCC matters only):
Apple Inc.
One Apple Park Way, MS 911-AHW
Cupertino, CA 95014
USA
www.apple.com/contact
•
•
•
•
Apple Inc.
One Apple Park Way, MS 911-AHW
Cupertino, CA 95014
USA
www.apple.com/hk/contact
ISED Canada
This device complies with ISED Canada licence-
exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not
cause interference, and (2) this device must accept
any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’ISDE
Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux
conditions suivantes : (1) l’appareil ne doit pas
produire de brouillage, et (2) l’appareil doit
accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d’en compromettre
le fonctionnement.
Exposure to radio frequency energy
The radiated output power of this device meets the
limits of FCC/IC radio frequency exposure limits.
This device should be operated with a minimum
separation distance of 20cm (8 inches) between
the equipment and a person’s body.
La puissance de sortie rayonné e cet appareil
est conforme aux limites de la FCC/IC limites
d’exposition aux fréquences radio. Cet appareil
doit être utilisé avec une distance minimale de
séparation de 20 cm entre l’appareil et le corps
d’une personne.
CAN ICES-3 (B)/NMB-3(B)
EU Compliance
Apple Inc. hereby declares that this wireless device
is in compliance with Directive 2014/53/EU.
A copy of the EU Declaration of Conformity is
available at
www.apple.com/euro/compliance.
Apple’s EU representative is Apple Distribution
International, Hollyhill Industrial Estate, Cork,
Ireland.
Frequency Maximum Power
326.5kHz < -15dBμA/m @ 10m