Technical data

3
ABOUT YOUR WATER HEATER
Product Application
This water heater is designed for use in a single family domestic dwelling
for the purpose of heating potable water. Its use in an application other
than this may shorten its life.
Model Type
Aquamax
®
electric storage water heaters are available with either a single
heating unit or with twin heating units (refer to “Single Element Model” and
“Twin Element Model” on page 4). The water heater can be installed in an
indoor or outdoor position and is not to be used as a pool heater.
Water is stored in a vitreous enamel lined steel cylinder and is heated by
an electric immersion heating unit (element). The thermostat controls water
temperature whilst automatic safety controls fitted to the water heater
provide safe and efficient operation.
Model Selection Chart
50 Litre
80 Litre
125 Litre
160 Litre
250 Litre
315 Litre
400 Litre
EM50S36 E80S18 E125S18 E160S18 E250S24 E315S36 E400S36
EM50S18L E80S24 E125S24 E160S24 E250S36 E315S48 E400S48
EM50S24L E80S36 E125S36 E160S36 E250S48 E315T36 E400T36
E125S48 E160S48 E250T36 E315T48 E400T48
E160T24 E250T48
E160T36
E160T48
E160S18X
E160S24X
E160S36X
E160S48X
Note: All models can be supplied with a ‘Hard Water Anode’. These models
have the suffix ‘HWA’ at the end of the model number.
Legend
E
or EM
(50L Only)
Electric Series 240V AC, 50Hz
50, 80
, ,...
400
Rated hot water delivery in Litres
S
Single bottom element
T
Twin element *
18, 24, 36, 48
Element wattage (1800W, 2400W, 3600W, 4800W)
X
Special short version
L
Fitted with a 240V AC, 10A power supply lead & plug
* Both elements are of the same wattage and are wired for non simultaneous
operation.