Installation Guide

INSTALLATION INSTRUCTIONS

4. Secure Bowl to Floor

Insert the bevel discs (HH) and bowl wing nuts (EE) onto the

T-bolts (AA). Tighten the bowl wing nuts (EE) to secure the

position of the bevel discs (HH). Place the bolt caps (GG) over

the T-bolts (AA) and snap into place.

CAUTION: Do not overtighten bowl wing nuts

because vitreous china can easily crack or chip.

Pour water into bowl to prevent the escape of sewer gases.

5. Install Tank-to-Bowl Seal

Turn the tank (B) upside down and press the tank-to-bowl seal

(II) into place over the lower tank opening.

Unscrew the metal at washers (JJ) and wing nuts (MM) from

the tank screws (CC). Lower the tank (B) onto the bowl (A) and

let the tank screws (CC) protrude through the mounting holes

on bowl (A). From the underside of bowl (A), thread metal at

washers (JJ) and wing nuts (MM) onto the protruding tank

screws (CC). Tighten the wing nuts (MM) alternatively until the

tank (B) is evenly seated on the bowl (A).

7. Attach Water Supply Line

Connect the water supply line (not included) to the tank (B) and

shut-o valve. Tighten the tank connection coupling nut 1/4 turn

beyond hand tight.

CAUTION: Do not overtighten the tank connection

nut.

Turn on supply valve and allow tank to ll. Check for leaks at all

connections and tighten or correct as needed.

6. Install Tank on the Bowl