Installation Guide

INSTALLATION INSTRUCTIONS

5. Secure Bowl to Floor

and snap into place.

room for the bolt caps (FF).

Pour water into bowl to prevent the escape of sewer gases.

CAUTION: Do not overtighten bowl nuts because

vitreous china can easily crack or chip.

8. Attach Water Supply Line

Connect the water supply line (not included) to the tank (B) and

shut-off valve. Tighten the tank connection coupling nut 1/4 turn

beyond hand tight.

CAUTION: Do not overtighten the tank connection

nut.

connections and tighten or correct as needed.

6. Install Tank-to-Bowl Seal

Turn the tank (B) upside down and press the tank-to-bowl seal

(GG) into place over the tank lower opening.

7. Install Tank on the Bowl

Unscrew the metal flat washers (II) and wing nuts (JJ) from the

tank screws (HH). Lower the tank (B) onto the bowl (A) and

let the tank screws (HH) protrude through the mounting holes

on bowl (A). From the underside of bowl (A), thread metal flat

washers (II) and wing nuts (JJ) onto the protruding tank screws

(HH). Tighten the wing nuts (JJ) alternatively until the tank (B)

is evenly seated on the bowl (A).