Operator`s manual
45
Rear Foot Brake
Pressing the rear foot brake downward will
apply the brake to the rear wheels.
KM130
Headlight OFF/HI/LO
Switch
Use the headlight OFF/HI/LO switch to
select the high or low headlight beam
when the ignition switch is in the
LIGHTS position. When the switch is in
the HI position, the high beam will illu-
minate. When the switch is in the LO
position, the low beam will illuminate.
When the switch is in the OFF position,
only the taillight will illuminate.
KM161C
Engine Stop Switch
OFF position
- The ignition circuit is off.
The engine cannot be started or will not
run. If the emergency stop switch is used to
stop engine without turning off ignition
switch, the battery may discharge.
RUN position - The ignition circuit is
on. The engine can start and run.
Starter Button
Pushing in on this button activates the
starter motor. Before starting the engine,
make sure the ignition switch is in the ON
position, the transmission is in neutral, and
the parking brake lock is engaged.
NOTE: This ATV has a safety
interlock switch which prevents the
starter motor from activating when
the transmission is not in neutral.
The interlock will be bypassed if the
hand brake lever is compressed or
if the auxiliary brake pedal is
depressed.
Reverse Override
These ATV’s are equipped with a reverse
speed limiter system. When additional
RPM is needed in reverse, depress and
hold the override button.
KM121C
Choke Lever
The choke lever is used to help start a cold
engine. Move the lever to the left to acti-
vate the choke. Return the lever to the
right position to de-activate the choke.
! WARNING
Never use the brake lever lock as a
parking brake or depend on it to hold
the ATV when parking on a hill. The
brake may relax if left engaged for a
long period of time. This could cause
an accident; therefore, do not leave
the ATV on a hill depending on the
brake lever lock. Always block the
downhill side of the wheels if leaving
the ATV on a hill or park the ATV in a
sidehill position.
! WARNING
Never activate the override while the
throttle is open as a loss of control
may result.