Safety data sheet

ManualsBrandsAREXX ManualsSoldering AccessoriesDesoldering braid Length 2 m Width 2.6 mm Dispenser

AREXX Engineering • T +31 (0)38 454 2028 • F +31 (0)38 452 4482 • info@arexx.nl • www.arexx.com

Technical specications:

Free oxygen copper braid

Free washing no clean formula Flux

ESD FREE ERGONOMIC HOUSING

Braid length 2 meter

Braid widh 1.7mm or 2.6mm

AUSMAN DESOLDERING WICK

AUSMAN ENTLÖTSAUGLITZE

After the development of the chem-wick and the no clean ux formula years ago, the desoldering wick

has not been changed anymore. JAMA and AREXX have developed a ergonomic dispencer to keep the

desoldering braid. This new ergonomic dispencer is much more user friendly than the regular dispencer.

Also there is less braid waste (1), which has positive advantages for our environment.

The ABS holder (3) and the metal tip (2) of the dispenser are non magnetic and ESD free. The no clean

ux formula implies that not only the solder will be absorbed but also the ux.

AW-100 & AW-200

TECHNICAL DATA SHEET

Nach der Entwicklung der “chem-wick”-Entlötlitze und die “no clean”-Flussmittel vor einigen Jahren

haben sich die Entlötlitzen kaum geändert. JAMA und AREXX haben einen ergonomischen Dispenser als

Behälter für die Entlötlitze entwickelt. Der neue, ergonomische Dispenser ist benutzerfreundlicher als der

standard-Dispenser. Zur Vermeidung von Umweltschäden wurde auch die Abfallmenge an Entlötlitze (1)

verringert. Der ABS-Behälter (3) und die Metallspitze (2) des Dispensers werden aus nicht magnetischem

Material gefertigt und sind elektrostatisch geschützt. Das “no-clean”-Attribut für das Flussmittel bedeutet,

dass die Entlötlitze nicht nur das Lötzinn, sondern auch das Flussmittel absorbiert.

Technische Spezikationen:

Entlötlitze aus reinem Kupfer

“noclean”-Flussmittel, das ein Waschen überüssig macht.

ESD-FREIER, ERGONOMISCHER BEHÄLTER

Entlötlitze-Länge 2 Meter

Entlötlitze-Breite 1.7mm oder 2.6mm

Summary of content (11 pages)

PAGE 1
After the development of the chem-wick and the no clean flux formula years ago, the desoldering wick has not been changed anymore. JAMA and AREXX have developed a ergonomic dispencer to keep the desoldering braid. This new ergonomic dispencer is much more user friendly than the regular dispencer. Also there is less braid waste (1), which has positive advantages for our environment. The ABS holder (3) and the metal tip (2) of the dispenser are non magnetic and ESD free.
PAGE 2
Desoldering When you made a soldering failure, you can easily remove the mistaken component with wick. Put the soldering wick on the solder path. Heat the wick and the path with the soldering iron and the copper braid of the wick will suck the solder. Entlöten When the wick removed all the solder from the path, pull back the wick and the soldering iron simultaneously Wenn wir beim Löten einen Fehler gemacht haben, können wir den Lötfehler mit Entlötsauglitze reparieren.
PAGE 3
AREXX SAFETY DATA SHEET AUSMAN DESOLDERING WICK AUSMAN ENTLÖTSAUGLITZE AREXX AW-100 and AW-200; Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II, as amended by Regulation (EU) No. 453/2010 -Europe SECTION 1 1.1 Product identifier Product name; AUSMAN WICK Product code; AW-100 and AW-200 Product description; Desoldering braid (litze) Product type; Solid Other means of identification; AUSMAN, DESOLDER WICK, ENTLÖTSAUGLITZE AW100, AW200 1.
PAGE 4
AREXX AW-100 and AW-200; Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II, as amended by Regulation (EU) No. 453/2010 -Europe SECTION 2 2.1 Classification of the substance or mixture Product definition : Mixture Classification according to Regulation (EC) No. 1272/2008 [CLP/GHS] Aquatic Acute 1, H400 Aquatic Chronic 1, H410 The product is classified as hazardous according to Regulation (EC) 1272/2008 as amended.
PAGE 5
AREXX AW-100 and AW-200; Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II, as amended by Regulation (EU) No. 453/2010 -Europe Special packaging requirements Containers to be fitted Not applicable. with child-resistant fastenings: Tactile warning of danger: Not applicable. 2.3 Other hazards Other hazards which do not result in classification: May cause allergic reactions in certain individuals. SECTION 3 3.
PAGE 6
AREXX AW-100 and AW-200; Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II, as amended by Regulation (EU) No. 453/2010 -Europe SECTION 4 4.1 Description of first aid measures Eye contact: Immediately flush eyes with plenty of water, occasionally lifting the upper and lower eyelids. Check for and remove any contact lenses. Continue to rinse for at least 15 minutes. Get medical attention if irritation occurs.
PAGE 7
AREXX AW-100 and AW-200; Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II, as amended by Regulation (EU) No. 453/2010 -Europe SECTION 5 5.1 Extinguishing media: Suitable extinguishing Use an extinguishing agent suitable for the fire. media: Unsuitable extinguishing None known media: Hazards from the This material is very toxic to aquatic life with long lasting substance or mixture: effects.
PAGE 8
AREXX AW-100 and AW-200; Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II, as amended by Regulation (EU) No. 453/2010 -Europe SECTION 6 Personal precautions, protective equipment and emergency procedures Basic precautions: Uses adequate ventilation, do not inhale the fumes Means of protection: Consult section 8 6.2 Environmental precautions: Do not dump into water or enviroment, water poluting material 6.
PAGE 9
AREXX AW-100 and AW-200; Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II, as amended by Regulation (EU) No. 453/2010 -Europe SECTION 8 Individual protection measures Respiratory protection: Use good workspace ventilation for soldering and do not breath the fumes Hand protection: Not necessary in normal use conditions Eye/face protection: Protective gogels are advised Skin and body protection: Do not eat or drink during use SECTION 9 9.
PAGE 10
AREXX AW-100 and AW-200; Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II, as amended by Regulation (EU) No. 453/2010 -Europe SECTION 12 \ Ingredient name Result Copper Acute EC50 1100 μg/l Acute EC50 2.1 μg/l Fresh water Acute IC50 13 μg/l Fresh water Acute IC50 5.4 mg/l Marine water Chronic NOEC 2.5 μg/l Marine water Chronic NOEC 0.02 mg/l Fresh water Chronic NOEC 0.
PAGE 11
AREXX AW-100 and AW-200; Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II, as amended by Regulation (EU) No. 453/2010 -Europe SECTION 14 Transport information: Not available. SECTION 15 15.1 Safety, health and environmental regulations/legislation specific for the substance or mixture EU Regulation (EC) No. 1907/2006 (REACH) Annex XIV - List of substances subject to authorisation Substances of very high concern None of the components are listed. Annex XIV None of the components are listed.