Specifications

AS1S
100
9. HOW TO INSTALL THE CEILING PANEL
■ 1-Way Air Dischange Semi-Concealed Type (AS1S Type)
9-1. Installing the Ceiling Panel
(1) Screw the M5 × 40 screws supplied (in the unit packing) into 4 points on the flange surface of the unit bolted to
the ceiling. Insert the screws so that the distance between the bottom of the screw head and the bottom surface
of the flange is at least 19.05 mm. (Fig. 9-1)
(2) Next, lift the ceiling panel in this position so that the 4 protruding screws pass through the key hole-shaped
openings in the panel, then shift the panel sideways until it is caught by the screws.
(3) Keeping the ceiling panel in this position, check to see if the joining edge of the ceiling panels are in line with
those of the ceiling material. If they are not in line, remove the ceiling panel and finely adjust the suspension
position of the unit.
(4) Once the joining edges are properly aligned with each other, install the supplied stoppers into the key hole-
shaped openings, then insert the 4 screws until the ceiling panel touches the flange surface of the unit.
Fig. 9-1
Unit
Ceiling face
Ceiling panel
Air-intake grille
Chain
Hook
Screw
M5 × 40 small screw (4)
Key hole-shaped
opening
Stopper
20 mm
123
Stoppers (2) are supplied with the ceiling panel at the
time of shipment.
NOTE
9-2. How to Use the Stoppers
(1) Pass through screws on the unit into the key hole-shaped openings on the panel.
(2) Then, shift the panel sideways until it is caught by the screws.
(3) Insert the stoppers in the direction of the arrow as shown, confirm that the bent portion of each stopper is
securely in the hole, A and B, then tighten the screw. (Fig. 9-1)
Accessory
Mounting
Insertion
direction
Accessory part
Insertion
direction
A
B
04-396 InverterW_p51-108 ARGO 12/21/04 10:17 AM Page 100