Specifications

ASBS
101
■ 1-Way Air Discharge Semi-Concealed Slim Type
(ASBS Type)
9-3. Installing the Ceiling Panel
(1) Hook the 2 panel catches of the ceiling panel to
the tubing side (stationary side) of the indoor unit.
Then, press up on the opposite side to engage the
level catch to install by opening the level catch
(pressed with fingers.) (Fig. 9-2)
Make sure the ceiling panel is mounted correctly.
(2) Fasten the M6 screws (supplied) into 4 points as
shown in Fig. 9-3.
(3) Install the wiring connector from the ceiling panel
to the connector from the indoor unit.
If the connector is not connected, a misoperation sig-
nal (“P9” on the remote control display) will be dis-
played when the unit is turned on.
NOTE
Never attempt to move the
louver by hand.
Since the louver has an
automatic air-sweeping
mechanism, it may be
damaged.
CAUTION
Panel catch
(level catch side)
Panel catch
(stationary side)
Side panel
Connector
(panel side)
Connector
(unit side)
Electrical
component
box
Side panel
Fig. 9-2
Fig. 9-3
04-396 InverterW_p51-108 ARGO 12/21/04 10:17 AM Page 101