Specifications

ACS
125
■ REM HLACS for Ceiling Mounted
(ACS Type)
11-6. Installing the Receiver Unit
(1) To take off the side panel, open the intake grille
and remove the screw. Then remove the side
panel by moving it toward the front (direction of
arrow). (Fig. 11-7)
(2) Wrap the end of a standard (flat) screwdriver
blade with vinyl tape. Then insert the screwdriver
blade into the groove on the side of the cover
below the “O” mark, and pry open the cover.
(Fig. 11-8)
(Take care not to scratch the panel.)
(3) Pass the lead wire through the panel, then install
the receiver unit in the panel hole.
(The projections on the receiver unit engage the
panel holes to attach the unit.)
(4) Fasten the receiver lead wire to the fastener that
holds the louver motor wiring. (Fig. 11-9)
(5) Reattach the side panel.
(6) Route the lead wire from the receiver unit along
the louver motor wiring and other wiring and fas-
ten them with a fastener. (Fig. 11-10)
* Access the hole at the top of the electrical compo-
nent box to draw in the wiring.
● Do not twist the control wiring with the power wiring
because this may cause malfunction.
● Install a noise filter or take other appropriate action
if electrical noise disturbs the unit’s power supply
circuit.
* For the wiring and test run procedures, refer to
“Wiring the Receiver Unit” and “Test Run.”
NOTE
Fig. 11-7
Panel
Intake grille
Side panel
Fig. 11-8
Insert into groove on
side below “O” mark.
Vinyl tape
Standard screwdriver
(wrapped with vinyl tape)
Cover
Fig. 11-9
Receiver unit
Clamp
Fig. 11-10
Terminal board
Clamp
Clamp
04-396 InverterW_p109-139 ARGO 12/21/04 10:30 AM Page 125