Specifications

ASBS
AS2S
130
(4) Attach the ceiling panel.
(5) Open the air-intake grille. Connect the display and
the control unit 6P relay connector (white).
At this time, pass the lead wire from the display
through the notch in the main unit, and use the
supplied vinyl clamp to bind the lead wire. Then
use the fastening clamp to fasten it to the service
cover. Also connect the ceiling panel wiring con-
nector.
* For the wiring and test run procedures, refer to
“Wiring the Receiver Unit” and “Test Run.”
11-15. Accessories
11-16. Wiring the Receiver Unit
● Connection diagram
1. Connect W1 to the indoor unit remote con-
troller wiring terminal. (It has no polarity.)
2. Connect W3 from the display and W2 from
the control unit to the relay connector.
11-17. Precautions on Simultaneous Installation
of Wired Remote Controller and Wireless
Remote Controller
By installing a wired remote controller, the wireless
receiver unit can permit dual remote control operation
at the same time.
(Up to 2 units of remote controllers – a wireless
remote controller and a wired remote controller – can
be installed.)
Dual remote control operation can control 1 or multi-
ple air conditioners using several remote controllers.
Fig. 11-19
Control unit
Service cover
Power-side lead wire
Clamp
Shaft
Vinyl clamp
Fan case
(3)
No.
1
2
3
4
5
Control unit
Display unit
Parts
Remote
control unit
Remote
control holder
AAA alkaline
battery
Spacer
Tapping screw
4 × 10
Tapping screw
4 × 16
Truss-head Phillips
Vinyl clamp
No.
Q'ty
Parts Q'ty
6
7
8
9
2
1
1
1
1
2
4
2
3
L 150
Control unit
CN1
6PWHT
6PWHT
2PWHT
WHT
BLK
W1 (1300mm)
1
2
W2 (200mm)
W3 (1200mm)
BLU
YEL
PNK
RED
GRY
BLK
BLU
YEL
PNK
RED
GRY
BLK
Remote
controller
terminal
board
Indoor unit
Display unit
Relay
connector
(6PWHT)
CN2
CN1
CAUTION
● Be sure to determine the cor-
rect terminal numbers on the
indoor unit when wiring the
remote controller. The remote
controller will be damaged if
high voltage (such as 200 VAC)
is applied.
04-396 InverterW_p109-139 ARGO 12/21/04 3:58 PM Page 130