Specifications

AS1S
ADS
ADPS
AFS
AFNS
133
11-19. Accessories Supplied with Separate
Receiver Unit
11-20. Important Information for Installation of
1 Separate Receiver Unit
<Installation location>
● Do not install in a location where the air contains oil
mist, such as in a kitchen or factory.
● Do not install next to a window, or in any other
location directly exposed to sunlight and outside
air.
● Do not install nearby devices which can be expect-
ed to produce electrical noise, such as elevators,
automatic doors, and industrial sewing machines.
● If the receiver unit is installed near a rapid-start
type or inverter-type fluorescent lamp (a lamp
which does not include a glow lamp), it may not be
possible to receive the wireless remote controller
signal in some cases. In order to prevent interfer-
ence from fluorescent lamps, leave a minimum of 2
meters between the receiver unit and the fluores-
cent lamps, and install the receiver unit in a loca-
tion where it can receive the wireless remote con-
troller signal when the fluorescent lamps are lit.
11-21. How to Install the Separate Receiver Unit
● To avoid malfunction of the remote controller, do
not assemble or run remote control wiring together
with the power cables, and do not enclose them in
the same metal conduit.
● When the power unit induces electrical noise, it is
recommended that a noise filter or the like be
installed.
NOTE
Fig. 11-22
1
3
2
4
6
5
Face plate
Remove
Screws
M4 × 25 (2)
Receiver unit
Spacer
2
(provided 200mm
power cable)
Plate
mounting
Screws
M4 × 25
Screws
M4 × 40
Wood
screws
1
2
3
4
5
No. Parts
Q'ty
No.
6
7
8
9
1
1
2
Parts Q'ty
4
2
1
1
Separate
receiver unit
Spacer
Wire joints
Clamp
Pattern template
95 × 51
2
unit: mm
■ REM HL for AS1S, ADS, ADPS, AFS, AFNS Type
04-396 InverterW_p109-139 ARGO 12/21/04 10:30 AM Page 133