Specifications

ACS

Fig. 3-90

Fig. 3-91

Fig. 3-92

Indoor

side

Outdoor

side

Fig. 3-93

Cut at sli

ht an

PVC pipe (locally purchased)

INSIDE

Wall

Slight

angle

PVC pipe

OUTSIDE

b) Lift the indoor unit, and place it on the washers

through the notches, in order to fix it in place.

(Fig. 3-90)

c) Tighten the 2 hexagonal nuts on each suspen-

sion bolt to suspend the indoor unit as shown in

Fig. 3-91.

The ceiling surface is not always level. Please confirm

that the indoor unit is evenly suspended. For the

installation to be correct, leave a clearance of about

10 mm between the ceiling panel and the ceiling sur-

face and fill the gap with an appropriate insulation or

filler material.

(8) If the tubing and wiring are to go towards the rear

of the unit, make holes in the wall. (Fig. 3-92)

(9) Measure the thickness of the wall from the inside

to the outside and cut PVC pipe at a slight angle

to fit. Insert the PVC pipe in the wall. (Fig. 3-93)

NOTE

The hole should be made at a slight downward slant

to the outside.

NOTE

04-396 InverterW_p51-108 ARGO 12/21/04 10:17 AM Page 58