Specifications

ACS

* Insert the remote controller

wiring into the electrical

component box from the

inlet port as shown in the

figure. This is done

regardless of whether the

wiring was inserted from

the top, rear, or left side of

the main unit.

Remote controller wiring inlet port

Power, inter-unit wiring

Power, inter-unit wiring, remote

controller wiring inlet port

Clamp

How to carry out power supply wiring

(1) Wiring connection ports

The power inlet ports are located at the rear and top.

The remote controller wiring inlet ports are located at

the rear and top (for use with the wired remote con-

troller).

For details, refer to Fig. 3-94a on page 58. For the

method used to insert the wiring, refer to the figure

below. (Fig. 3-97)

(2) How to carry out wiring

● Open the knock-out hole on the rear or top of the

main unit. Attach the supplied rubber grommet and

pull the power wiring into the main unit.

● Feed the wiring into the wiring inlet port on the

electrical component box. Connect the wiring to the

terminal plate and fasten in place with the supplied

clamp.

● Perform electrical and grounding work in accor-

dance with the package A/C power specifications,

and following local electrical codes and regulations.

CAUTION

When removing the fasten-

ing bracket from the cover

of the electrical component

box, use caution to avoid

dropping the bracket.

Fig. 3-97

04-396 InverterW_p51-108 ARGO 12/21/04 10:17 AM Page 61