Specifications

AFS
AFNS
76
Fig. 3-125
Fig. 3-126
B
A
Front panel
Tab
Side panel
Dew-prevention
heater
Fixture
Chain
Lead-wire connector
(2p Red)
Front panel
3-44. Removing and Attaching the Front Panel
(Floor-Standing Type)
A dew-prevention heater is secured behind the front
panel. When removing or attaching the panel, take
care not to damage the lead wire to the heater.
How to remove the front panel
(1) Remove the 2 screws at the lower part of the front
panel.
(2) Holding
A at the upper right of the unit, push up at
B at the lower right of the panel. The right side of
the front panel is removed. Then remove the left
side of the front panel following the same proce-
dure.
(3) Disengage the lead wire connector (2P red) for the
dew-prevention heater.
(4) Remove the chain connecting the front panel of
the unit by unhooking it from the fixture attached
to the panel.
How to attach the front panel
(1) Hook the chain to the fixture of the front panel.
(2) Connect the lead wire connector.
(3) Align the slots at the lower part of the front panel
to the tabs at the lower part of the indoor unit and
put the upper trim tab of the front panel on the
groove of the unit. Then press down the panel.
(4) Insert the 2 screws at the lower part of the front
panel.
3-45. Installing the Refrigerant Tubing
(1) When connecting the wide tube use the supplied
tubing.
(2) Tubes can be extended in 2 directions: downward
and at rear.
For floor-standing type
● When a rear tube is required, it can run through the
rear-tube outlet of the rear panel.
● When a downward tube is required, refer to the
opening dimensions shown in Fig. 3-127.
NOTE
04-396 InverterW_p51-108 ARGO 12/21/04 10:17 AM Page 76