EN TABLE AND STAND FAN OPERATING INSTRUCTIONS Read the instructions carefully before operating the appliance or carrying out maintenance operations. Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damage. Keep these instructions in a safe place for future reference.
GENERAL SAFETY INFORMATION • Use this fan only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to people. • Ensure that the mains power complies with the voltage specified on the fan ’s data plate (220-240V~/50Hz). • This product is not a toy. Children should be adequately supervised to ensure that they do not play with the appliance.
Ginger - TABLE FAN - DESCRIPTION OF PARTS 1 1 2 2 3 4 5 1. Front grille 2. Nut 3. Blade 4. Swing control 5. Body 6. Control panel 7. Base 6 7 Tulip - STAND FAN - DESCRIPTION OF PARTS 10 1 2 2 13 3 3 4 4 11 11 5 6 12 8 7 1. Front grille 2. Nut 3. Blade 4. Ring 5. Body 6. Control panel 7. Inner rod 8. Height adjustment ring 9. Base 10.Handle 11. Motor housing 12.Screw 13.
TABLE & STAND FAN - ASSEMBLY INSTRUCTIONS Open the box and remove the parts of the appliance. Motor shaft. Tighten the nut on the motor shaft Insert the rear grill on the motor shaft in the proper position (handle upward). Screw the nut in order to fasten the rear grill firmly. Set the blade on the motor shaft.
Tulip - STAND FAN - ASSEMBLY INSTRUCTIONS OF THE BASE Open the box and remove the parts of the appliance. CONNECT THE ROD TO THE BASE USING THE SUPPLIED LOCKING LEVER AND FOLLOW THESE INSTRUCTIONS: 1. The fan is supplied with the locking lever included into the outer rod. 2. Loose the locking lever. 4 Insert the base below the outer rod. 5. Tighten the locking lever. 3. Remove the locking lever. 6. The base is inserted. 7. Unscrew the ring for adjusting the height and pull out the inner rod. 8.
HOW TO USE THE APPLIANCE Connect the power cord to a suitable power socket (220-240 V~). Do not use this fan in an area with high humidity, rich of dust or water. Tilt adjustment: to regulate the air flow upward or downward, after switching off the units, push gently the motor housing and adjust the angle of inclination. ON/OFF operating TIMER : • ON - fan on • OFF - fan off • 40-80-120: operation timer – the fan works respectively for 40-80-120 minutes.