Assembly Instructions

ManualsBrandsArgos Home ManualsHome and furniture60 Litre Monks Bench Style Laundry Box - White

Monk’s Bench Style Linen Bin

Dimensions

Width - 55cm

Depth - 35cm

Height - 58cm

Important – Please read these instructions fully before starting assembly

THIS PRODUCT IS NOT

DESIGNED OR INTENDED

AS A TOY STORAGE CONTAINER

If you need help or have damaged or missing parts, call the Customer Helpline: 0845 640 0800

Assembly Instructions- please keep for future reference

Issue 3 - 24/08/10

LP 255.96.774

If you need help or have damaged or missing parts, call the Customer Helpline: 0845 640 0800

Assembly Instructions

Step 12

Screw the right side

panel

the ends of

the rails using 5 x 40mm

screw

as shown.

Ensure that the right-

hand hinge of the lid is

properly located in its

hole in the right side

panel.

Step 13

Drop the base panel

onto the bottom rails

inside the unit.

Step 14

Lift the lid and connect

the hinge

to the lid

and the top back rail as

shown using 4 x 12mm

screw

Important:

The hinge

must must be

attached the

correct way up.

Please pay attention to

diagram

a: for correct

installation.

Assembly complete.

832/5299

spring

Summary of content (4 pages)

PAGE 1
Assembly Instructions Monk’s Bench Style Linen Bin Step 12 Assembly Instructions- please keep for future reference Screw the right side panel 6 the ends of the rails using 5 x 40mm screw B as shown. 832/5299 B Ensure that the righthand hinge of the lid is properly located in its hole in the right side panel. 6 Step 13 Drop the base panel 9 onto the bottom rails inside the unit. 9 Step 14 Lift the lid and connect the hinge F to the lid and the top back rail as shown using 4 x 12mm screw G .
PAGE 2
Components - Panels Safety and Care Advice Important – Please read these instructions fully before starting assembly • Check you have all the components and tools listed on pages 1 and 2. • Do not stand or put weight on the product, this could cause damage. • Remove all fittings from the plastic bags and separate them into their groups. • Assemble the item as close to its final position (in the same room) as possible.
PAGE 3
damaged or missing components, Components - Fittings Ifcallyouthehave Customer Helpline: 0845 640 0800 Assembly Instructions Please check you have all the fittings listed below Step 3 Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings may be supplied than are required. A Connector x 10 B 40mm Screw x 10 Insert 2 x connector A into the holes in the bottom front rail 3 as shown.
PAGE 4
Assembly Instructions Assembly Instructions Step 6 Screw both the hinges D to the lid 10 using 4 x 12mm screw E . Important: the hinge must fit flush to the edge of the lid (a:). If the hinge post protrudes from the lid as shown (b:), the lid will not fit the linen bin. a: Screw the top front rail 1 and the bottom front rail 3 to the left side panel 5 using 2 x 40mm screw B . 10 5 3 D Step 10 B Screw the top back rail 4 and the bottom back rail 2 to the left side panel 5 using 3 x 40mm screw B .