User Manual

5/6
Electrical Operational Parameters
Rated voltage
AC110V~120V
Rated frequency
60HZ
Rated current
14A
Rated power
1500W
Maintenance:
 The drain can be clogged by hair or soap scum and should be cleaned regularly.
 Poor maintenance, infrequent, or irregular cleaning can cause damage to the faucets or jets.
 When cleaning the chrome parts, do not use cleaning compounds or instruments with abrasives or harsh chemicals. Do not try to
remove stains with hard objects, such as blades or screwdrivers.
 When cleaning the acrylic surfaces of the bathtub, use a soft sponge and a detergent without ammonia, acetone or other harsh
chemicals, to prevent surfaces from getting dulled or damaged.
 Dulled surfaces can be refinished with an acrylic polishing compound (follow instructions of polishing compound); first test on a
non-visible surface area.
 Consider cleaning the whirlpool features monthly with a whirlpool cleaning solution from your local hardware store. Follow the
instructions of the whirlpool cleaning solution. If not cleaned regularly you may notice black flakes in the bath – ifthis happens
you should clean the whirlpool system. Consider cleaning the whirlpool system with whirlpool cleaning solution repeatedly until
the black flakes disappear. Soap scum, hair, dead skin, skin care products, oil, grease and/or bacteria can contaminate your
whirlpool system, it is important to clean regularly.
 Consider cleaning the whirlpool system using a cup of chlorine bleach (sodium hypochondria) and the minimum amount of warm
or hot water to activate the (water-level sensor) whirlpool system, in between regular cleanings with whirlpool cleaning solution.
Thoroughly flush and rinse the bathtub and whirlpool system before use. (This is not meant as a substitute for whirlpool cleaning
solution)
Warning: The use of cleaning materials other than those recommended by the manufacturer can result in damage to the
bathtub, whirlpool apparatus, or other hardware.
Warning: Any service, adjustment or repair is only recommended by an experienced professional. Only consider a licensed
professional for all installation, servicing or repair work.
Test standard:
EN 12764: 2004+A1: 2008
EN 60335-2-60 (Low Voltage Directive 73/23/EEC)
EN 1111
1. The instructions for appliances connected to the water mains shall state:
- the maximum inlet water pressure is 72 PSI (0.5mPa / 5 bars)
- the minimum inlet water pressure is 15 PSI (0.1mPa / 1 bar), if this is necessary for the correct operation of the appliance.
2. Guidance on the testing and resetting of Residual Current Devices.
← "L" = Live = Black or Brown
← "N" = Neutral = White or Blue
← "G"= Earth-Ground = Green or Yellow
3. Maximum hot water temperature: 176°F (80°C).