Full Product Manual
Table Of Contents
- Welcome
- Safety
- Practices & Laws
- Emission Control System
- Required Operator Training
- Safety Alert Symbol
- Signal Words
- Safety Decals
- Safety Rules
- Controls and Features
- Ignition Key
- Choke Control Knob
- Throttle Control Lever
- Power-Take-Off (PTO) Knob
- Hour Meter
- Height-of-Cut Dial
- Deck Lift Pedal
- Seat Adjustment Lever
- Parking Brake Lever
- Safety Interlock System
- Steering Levers
- Transaxle Bypass Levers
- Anti-scalp Rollers
- Operation
- Emergency Stopping
- Before Operating Unit
- Start the Engine
- Operate Unit
- Stop the Engine
- Move Unit Manually
- Transport Unit
- Maintenance
- Maintenance Schedule
- Service Parts
- Service Position
- Check Safety Interlock System
- Check Parking Brake
- Check Engine Oil
- Check Tire Pressure
- Check Carbon Canister Filter
- Check Fasteners
- Lubricate Unit
- Check Mower Blades
- Check Battery
- Check Mower Belts
- Hydraulic Oil
- Adjustments
- Adjust Seat
- Adjust Steering Levers
- Adjust Unit to Track Straight
- Adjust Parking Brake Lever
- Remove and Install Mower Deck
- Adjust Mower Deck
- Troubleshooting
- Storage
- Short-Term Storage
- Long-Term Storage
- Start-of-Season Preparation
- Accessories
- Specifications
- Warr anty
- Blank Page
EN - 30
5. Remove deck drive belt from rear drive
pulley. See Figure 38.
See Figure 39.
6. Remove one hairpin from drag link to
disconnect drag link from mower deck
bracket. Retain all parts for reinstallation.
7. Repeat step 6 on other side.
8. Remove one flange nut, one hex bolt, one
flat steel washer and two sleeve bushings
from deck lift lever. Retain hardware. See
Figure 40.
9. Repeat step 8 for the three remaining
deck lift levers.
10. Move deck from under unit.
Install Deck
1. Position deck under unit.
See Figure 41.
2. Align holes in deck lift lever with slot in
deck link.
3. Position one 1/2 x 3/4 x 3/64" (shorter)
sleeve bushing between deck link and
interior bracket of deck lift lever.
4. Insert 3/8 x 1/2 x 1" (longer) sleeve
bushing through slot in deck link and
shorter sleeve bushing.
5. Insert hex bolt through washer, deck lift
lever, deck link and sleeve bushings.
Secure with flange nut.
Figure 38
Figure 39
1. Mower Deck Bracket
2. Drag Link
3. Hairpin
1
3
2
Figure 40
1. Deck Lift Lever
2. Flange Nut
3. Hex Bolt
4. Flat Steel Washer
5. Sleeve Bushings
1
5
2
3
4