Manual

2008-10 JEEP LIBERTY

Page 1 of 3

Driver Side Mounting Brackets Passenger Side Mounting Brackets

PARTS LIST:

1 Passenger Sidebar 4 10-1.50mm x 25mm Bolt Plates

1 Driver Sidebar 4 10mm Nylock Nuts

1 Passenger/Right Front Mounting Bracket 4 10mm ID x 26mm OD x 3mm Flat Washers

1 Passenger/Right Rear Mounting Bracket 8 8-1.25mm x 25mm Hex Head Bolts

1 Driver/Left Front Mounting Bracket 8 8-1.25mm x 35mm Hex Head Bolts

1 Driver/Left Rear Mounting Bracket 8 8mm Nylock Nuts

6 Fit Adjustment Spacers (127 x 25 x 3mm) 8 8mm Lock Washers

24 8mm ID x 22mm OD x 1.5mm Flat Washers

INSTALLATION INSTRUCTIONS

SIDE BAR PART #201005-2/201005

Bolt Plate

(4 pcs)

Fit Adjustment Spacers

(6 pcs)

PAGE 1
INSTALLATION INSTRUCTIONS 2008-10 JEEP LIBERTY SIDE BAR PART #201005-2/201005 PARTS LIST: 1 1 1 1 1 1 6 Passenger Sidebar Driver Sidebar Passenger/Right Front Mounting Bracket Passenger/Right Rear Mounting Bracket Driver/Left Front Mounting Bracket Driver/Left Rear Mounting Bracket Fit Adjustment Spacers (127 x 25 x 3mm) Driver Side Mounting Brackets 4 4 4 8 8 8 8 24 10-1.50mm x 25mm Bolt Plates 10mm Nylock Nuts 10mm ID x 26mm OD x 3mm Flat Washers 8-1.25mm x 25mm Hex Head Bolts 8-1.
PAGE 2
PROCEDURE: 1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. 2. Starting on the driver side front of the vehicle, insert (1) 10-1.50mm x 25mm Bolt Plate into rectangular hole located in the side panel, so threaded Bolt Plate drops through round hole (Figure 1). 3. Partially hang driver side front Mounting Bracket to already inserted Bolt Plate using the included (1) 10mm Nylock Nut and (1) 10mm Flat Washer to secure it (Figure 2).
PAGE 3
Fig 2 Fig 3 Fig 4 Fig 5 Fig 6 Fig 7 Page 3 of 3