IN NSTALL LATIO ON INST TRUCT TIONS S GRIL LLE GUAR RD 07-14 TOY YOTA TUN NDRA 08-14 TOY YOTA SEQ QUOIA PART # 2067/20677-2
G GRILLE GUARD D 07-14 TOYOT TA TUNDRA, 08-14 SEQUOIA A PA ARTS LIST: 1 Grille e Guard 2 1 1 1 1 1 1 4 4 4 Drive er/left Frame Mounting M Bra acket Pass senger/right Frame Mountin ng Bracket Drive er/left Top Fra ame Bracket Pass senger/right Top T Frame Bra acket Drive er/left Top Bra acket Pass senger/right Top T Bracket 12-1..
GRILLE GUARD 07-14 TOYOTA TUNDRA, 08-14 SEQUOIA from below, remove the hardware attaching the bumper cover to the cross member to access the end of the frame and bracket, (Figure 2). 4. Select the passenger side Top Frame Bracket, (Figure 3A). Remove the top (2) factory hex nuts on the outside and the single hex nut on the inside attaching the factory bumper bracket to the end of the frame on the passenger side, (Figure 3B). 5.
G GRILLE GUARD D 07-14 TOYOT TA TUNDRA, 08-14 SEQUOIA A 2 20. Slowly close the hoo od and check k for clearance. Release e both Quickk Release bo olts. Push the e Grille Guard into the "close ed" position. If needed, loosen the u pper bolt on n each Frame Mounting Bracket, (Figure 16). 1 WARNING! Do not completely loosen boltss or damage to the truckk or Grille Gu uard may occur. 2 21. Push the e Grille Guarrd back towa ards the vehiicle and fullyy tighten all h hardware, (F Figure 17 & 18).
G GRILLE GUARD D 07-14 TOYOT TA TUNDRA, 08-14 SEQUOIA A Passenger/right Side S Installlation Pictu ured Rem move (2) top p factory hex nuts on outside of bumper brack ket Front Remove R (1) ffactory hex nut n on inside e of bracket Pass senger side top b bracket F Front ((Fig 3B) Pass senger side Top Brackett pictured insttalled over bumper b brack ket. Pictured d from below w (Fig 4) Reus se factory he ex nuts to sec cure Top Bracket to e end of frame e.
G GRILLE GUARD D 07-14 TOYOT TA TUNDRA, 08-14 SEQUOIA A Passenger/right Side S Installlation Pictu ured Front (Fig 7) The e heavy duty y factory tow hooks can nnot be reins stalled. (F Fig 8A) Passe enger side Frrame Mountiing Bracket Front Front (Fig 8B) Install Frame Bracket with factory f b Small tow t hook pic ctured tow hook bolts.
G GRILLE GUARD D 07-14 TOYOT TA TUNDRA, 08-14 SEQUOIA A Passenger/right Side S Installlation Pictu ured Attach A Top B Bracket to Frame F Brack ket with: (2) 8mm x 25 5mm Hex Bollts (2) 8mm Lock k Washers (2) 8mm Flat Washers Front Front (Fig 10A) Passenger side s Top Bracket and Top p Frame Brac cket illustrate ed (2) 8mm x 25mm Hex Bolts (2) 8mm Lock L Washerrs (2) 8mm Flat F Washers s Insert (1) 12mm He ex Bolt and Washe ers per side then t rotate Grille Guard G up and in position n ( Fig 10B) Driv
G GRILLE GUARD D 07-14 TOYOT TA TUNDRA, 08-14 SEQUOIA A Passenger/right Side S Installlation Pictu ured Grrille Guard up pright 2) 10mm Plas stic (2 Washers W 10 0mm Flat Wa asher 10 0mm Nylon L Lock Nut In nsert a 10mm m Plastic Washer betwee en the G Grille Guard a and the Top Bracket and under th he Flat Wash her on each Q Quick Releas se Bolt.
G GRILLE GUARD D 07-14 TOYOT TA TUNDRA, 08-14 SEQUOIA A Passenger/right Side S Installlation Pictu ured Quick R Release in "closed" position Push h Grille Guarrd back to th he "closed" position p Front Fig g 17 Fig 18 8 Opening and closin ng the hoo od-required d for 2007--13 models s only 2 23. Lift the le evers on the Quick Relea ase bolt to re elease the cclamping pre essure, (Figu ure 14). Pulll the Grille Guard ou ut and away from the vehicle to the "open" " posittion, (Figure e 15).