User guide

2012-13 FIAT SPORT SIDERAIL

PARTS LIST:

Qty Description Qty Description

1 Driver/Left Side Rail 4 10mm Flat Washer

1 Passenger/Right Side Rail 4 10mm Lock Washer

4 10mm x 38mm Bolt Plate 4 10mm Hex Nuts

4 Plastic retainers

PROCEDURE:

REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ

INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.

2. Starting by partially threading a Plastic Retainer onto the threaded end of (2) Bolt Plates, (Fig

1A) above shows one example.

3. With the bolt plates ready, Starting on the Passenger/right side front Insert the Bolt Plate into

the factory floorboard hole, located just under vehicles floor board behind front tire, Once the

Bolt Plate is inserted, hold the Bolt end with one hand and tighten the Plastic Retainer with

your other hand, NOTE: Tighten the Plastic Retainer until it reaches the floor panel. (Fig 2)

Shows Bolt Plate installed with out plastic retainer for view.

4. Next proceed with the passengers/right side rear you will need to first remove the (5) Hex bolts

holding the bottom lip of the plastic body kit along the rocker panel edge so you can bend it

down slightly to expose the (3) Philips head screws holding the black plastic panel, covering

the mounting hole, (Fig 3) shows location of hex bolts. NOTE: do not remove body kit.

Page 1 of 3 12/19/2011)

INSTALLATION INSTRUCTIONS

PART# B505555 / 505555

Passen

er ri

ht Side rail

Driver left Side rail

10mm x 38mm Bolt Plate

(pictured with Plastic

Retainer installed for

example)

Fig 1A

Front of Vehicle

PAGE 1
INSTALLATION INSTRUCTIONS 2012-13 FIAT SPORT SIDERAIL PART# B505555 / 505555 PARTS LIST: Qty 1 1 4 4 Description Driver/Left Side Rail Passenger/Right Side Rail 10mm x 38mm Bolt Plate Plastic retainers Qty 4 4 4 Description 10mm Flat Washer 10mm Lock Washer 10mm Hex Nuts Driver left Side rail Front of Vehicle Passenger right Side rail Fig 1A 10mm x 38mm Bolt Plate (pictured with Plastic Retainer installed for example) PROCEDURE: 1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT.
PAGE 2
5. Remove the (3) Philips screws along the edge of the rocker panel remove these first followed by the (2) plastic push pins at the rear of this plastic panel, next (1) Philips head screw towards the front of the panel and 1 plastic nut towards the front middle (Fig 3A) shows location of screws, push pins & Nut to be removed. NOTE: the model shown is with out the body kit to show location of screws. 6.
PAGE 3
Shown without body kit Fig 3A Remove Philips screws Fig 4 Remove plastic nut Remove rubber plug Remove push pins Fig 5 Fig 6 Passenger/right side front Attach with 10mm Flat washer 10mm Lock washer 10mm Nut Fig 7 Installation complete Passenger/right side rear Attach with 10mm Flat washer 10mm Lock washer 10mm Nut Page 3 of 3 12/19/2011)