INSTALLATION INSTRUCTIONS BULL BAR 2014 TOYOTA HIGHLANDER PART #35-2009; B35-2009
BULL BAR 2014 TOYOTA HIGHLANDER PARTS LIST: 1 1 1 1 1 2 2 Bull Bar Driver/Left Mounting Bracket Passenger/Right Mounting Bracket Driver/Left Support Bracket Passenger/Right Support Bracket 12-1.75mm x 90mm Bolt Plates 12-1.75mm x 45mm Hex Bolts 2 8 2 4 2 2 2 12-1.75mm x 35mm Hex Bolts 12mm x 32mm OD x 3mm Flat Washers 12mm Lock Washers 12mm Nylon Lock Nuts 10-1.
BULL BAR 2014 TOYOTA HIGHLANDER knife or hacksaw blade to cut out the traced area for the Mounting Brackets. IMPORTANT: To maintain strength in the splash guard, only remove necessary material to clear the Mounting Brackets. Next, use a 1/2" drill bit or a sharp knife to open a hole for the threaded end of the (2) Bolt Plates to go through as described in Step 4. 10. Temporarily re-install the splash guard using the factory hardware.
BULL BAR 2014 TOYOTA HIGHLANDER Passenger Side Installation Pictured 12mm Bolt Plate Remove factory bolt Front (Fig 4A) 12mm Bolt Plate Front (Fig 4B) Insert Bolt Plate down through holes in cross member (Fig 5A) Passenger Frame Bracket Replace factory bolt with 10-1.
BULL BAR 2014 TOYOTA HIGHLANDER Passenger Side Installation Pictured Front (2) 12mm x 45mm Hex Bolts (2) 12mm Lock Washers (2) 12mm Flat Washers Fig 7 12mm x 35mm Hex Bolt (2) 12mm Flat Washers 12mm Nylon Lock Nut Front Hold the splash guard up to the bottom of the Brackets. Trace the location of the Brackets onto the inside of the splash guard. Cut (2) openings through splash guard for Mounting Brackets (illustrated for example only.
