Installation Guide
10
lter” is not display, and the hood has the normal display
operation.
Charcoal lter saturation alarm (Recirculating accessories)
• After one hundred and twenty functional hours of the fan, the
display will show “Charcoal Filter” if the fan is active. When
this icon ashes on display, the charcoal lters installed are
required to be replaced or reactivated.
• To reset the grease lter saturation indication the user must
press the “-” key for 5 seconds, after this time the icon
“charcoal lter” is not display and the hood has the normal
display operation.
Audible signal activation and deactivation
• The audible signals can be activated or deactivated pressing
the “Light” key for 5 seconds.
• If the audible signal is activated, a tone must sound and the
“Snd” symbol must appear on the display for 2 second.
• If the audible signal is deactivated, the “Snd” symbol must
appear on the display for 2 second and no sound must
sound.
Charcoal lter inclusion and exclusion (Recirculating
accessories)
• The charcoal lter inclusion or exclusion can be set by
pressing the “-” and “+” keys at the same time for 5 seconds.
• The Inclusion or exclusion of charcoal lter must be selected
while the lamps and the motor are OFF.
• When the charcoal has been excluded, the charcoal lter
alarm is disabled.
Heat sensor
• The control is equipped with a heat sensor that will turn on
the blower at second speed if excessive heat occurs (over
70°C) surrounding the control area.
• If the blower is OFF or if it is operating at rst speed, the
blower will be set automatically to second speed.
• During this state, the user may raise the blower speed to third
speed but can not decrease the speed.
• When the temperature level on the hood drops to normal, the
blower will operate in the setting dened by the user before
the alarm occured.
Range Hood Care
Cleaning
IMPORTANT: Clean the hood and grease lters frequently
according to the following instructions. Replace grease lters
before operating hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool or
soap-lled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
• Liquid detergent soap and water, or all-purpose cleanser
• Wipe with damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
• Do not use cleaning agents containing bleach.
Aluminum Grease Filter:
1. Remove the lter by pulling the spring release handle and
then pulling down the lter.
A
A. Spring release handle
2. Wash aluminum grease lters as needed in dishwasher
or hot detergent solution.
3. Reinstall the lter by making sure the spring release handles
are toward the front. Insert aluminum lter into upper track.
4. Push in spring release handle.
Push up on aluminum lter and release handle to latch
into place.
Replacing a LED Lamp
The LED lights are replaceable by a service technician only. See
the service contact information in the next page.