User Manual

\ 21

ton pressed for at least 2 seconds again.

7. RESET button

By pressing the recessed RESET button, all the current settings are cancelled and

replaced by the initial settings.

8. + button

Press this button to raise the set temperature or to increase the time value during the

timer programming.

9. - button

Press this button to lower the set temperature or to decrease the time value during

the timer programming.

10. SILENCE/ECO

(in models equipped with this function)

Used to enable and disable the silence function. Press and hold for 2 seconds to

enable the ECO function (in models equipped with this function); to disable it, simply

press and hold the button again for longer than 2 seconds.

11. FAN SPEED button

Use this button to select the fan speed in the four options available in sequence:

AUTO > LOW > MED > HIGH

12. TIMER button

It is used to set the automatic start up/shut down delay via the timer. Each time the

+/- button is pressed, the delay setting increases/decreases by 30 minutes. When

the set delay reaches the value of 10:00, as indicated on the display, each time the

+/- button is pressed, the automatic shut down delay setting increases/decreases by

60 minutes. To cancel the programming via the timer, just set the delay to 0:00.

13. MEMORY button

It is used to save the current settings or restore the previous settings.

14. LED/FOLLOW ME button

It deactivates and activates the LED function. By keeping it pressed for more than 2

seconds, the FOLLOW ME function is activated. To deactivate it, just keep the button

pressed for more than 2 seconds again.

15. LOCK button

By pressing the recessed LOCK button, all the current settings are locked and the

remote control system no longer responds to any command, except the LOCK but-

ton being pressed. Press it again to cancel the LOCK mode.

NOTE:

All the function described above are carried out by the internal unit. If the latter does not

have a certain feature, by pressing the respective button on the remote control system

no operation is activated.