Technical information

17
For further information relating to flue runs not illustrated, please
contact the Technical Department on 0870 241 8180.
123,5 135
230 MIN *
200
132
Fig. 2.17
ø 100
60 mm
In the event that twin flue pipes are used, and the boiler
has a side clearance of less than 60mm from the wall, it
is necessary to cut a larger diameter hole for the flue
pipe, this should be ø10 cm, this will then allow for easier
assembly of the air intake elbow and the tube outside the
wall (see Fig. 2.17).
FIG. 2.18
EXHAUST
AIR INTAKE
AIR INTAKE
AIR INTAKE MUST NOT BE
FITTED ABOVE THE EXHAUST
FIG. 2.19