Installation & Assembly

1) Find the centerline of where the unit will be
installed. This will usually be the center of the
curb of the shower pan. Place a centerline mark
at each end of the curb where it meets the wall.
This mark will also represent the center of the
ZD1006 Wall Jamb (#1). Place the wall jamb
against the wall and on top of the centerline
marks
(A). Use a level to position the jamb
plumb, then mark the installation holes with a
pen or pencil
(A2). Repeat this procedure for
the other jamb. Now drill the 6 holes with a
3/16” masonry bit (9/64” for fiberglass, & with-
out anchors). Then insert the 6)-ZV935 screw
anchors (#9) in the holes. Fasten the ZD1006
wall jambs in place using the #8X1-1/4 Phillips
Pan Head screws provided (#10)
(B).
2) Slide the ZD8004 “Magnetic Latch Jamb” (#2)
over the latch side wall jamb. (
Note: There are
two ZD8004’s. The “Magnetic Latch Jamb” is
not
attached to the Door Glass.) Next install the
door by sliding the ZD8004 “Door Hinge Jamb”
(#2) over the hinge side wall jamb. Do not fas-
ten the door at this point
(C).
Installation Instructions for
Model MP Door
Note:
These instructions will refer to the item #’s in the Exploded View drawing. For example, #1, #2, #3 etc…
Please read through all of the instructions to get an over-view before you install the shower door.