Installation & Assembly

5)
Place a small amount of silicone on the legs
of the 2-ZV940 Door Clips (#20) and place down
into the top of the 1006’s to cap the opening.
You may have to trim them to fit with side cut-
ters
(G).
6) Measure in-between the ZD8004 “Magnetic
Latch Jamb” and the ZD8004 “Door Hinge Jamb”
on top of the curb where the door is going to
sit. Cut the ZD2026 to this dimension. Run a
bead of silicone underneath the ZD2026 then
set in place between the two ZD8004’s. Use
tape to hold in place, preferably blue tape
(H).
7) Cut the Bottom Poly Rail (ZVP-14WS for 1/4”
glass (#22)) then push over the bottom edge of
the glass. Run a cap bead of silicone on the in-
side where the glass and poly meet to prevent
water seeping down into the sweep between
the glass and poly. (
Note: to ensure that the
door will close completely, notch out the sec-
tion of plastic that makes contact with the
ZD8004 “Magnetic Latch Jamb”)
(I).
8)
Run a bead of silicone on the inside and out-
side where the wall jamb meets the shower
wall. Inspect the install and caulk any gap that
might let water through
(J).