Arizona Corporate Office 2801 W. Indian School Rd Phoenix, AZ 85017 800-255-1901 PH 602-447-8208 FAX Florida 8100-1 Westside Industrial Dr Jacksonville, FL 32219 855-695-8899 PH 904-786-9025 FAX Illinois 2601 Bond St #1 University Park, IL 60484 800-861-6120 PH 708-235-0729 FAX Oregon 2057 Lars Way Medford.
Installation Instructions for Model ETE-3/8 & ESE-3/8 Note: These instructions will refer to the item #’s in the Exploded View drawing. For example, #1, #2, #3 etc… Please read through all of the instructions to get an over-view before you install the door. 1) Find the centerline of where the unit will be installed. This will usually be the center of the ledge of the bath tub or the curb of the shower pan. Place a centerline mark at each end of the tub ledge or curb where it meets the wall.
2) Measure the distance between the inside of the wall jambs (just above the tub ledge or curb). Measure tight and deduct 1/16” to 1/8” to get the cut size of the ZTE7222 Curb (#3) (E). Cut to size. Apply silicone where wall jambs meet tub or curb. Then run a bead along the underneath of the ZTE7222 Curb (F). Slide the curb down between the wall jambs and onto the tub/shower. Make sure the curb is solid and doesn’t rock back and forth.
until the top rollers can be guided up into the inside roller track of the header. Lift up glass then slowly lower the rollers into the inside roller track and let the panel hang in its vertical position. The outside panel will be installed the same way. Make sure the rollers are facing toward you. A helper would be valuable at this point to hold the inside panel on an angle toward the inside so that the outside panel can be lowered and positioned to be installed into the outside roller track.
shower) then running a #6X3/8 screw into the hole (K). 7) *please see attached before proceeding Attach the ASD-1 (#10) Knob Pull (L) by inserting the threaded bolt with grommet through the hole. This will be the inside panel with one hole which will be on the showerhead side of the opening. The knob should be on the inside. Also make sure the plastic washers provided are on each side of the glass. Use the small Allen wrench provided to insert into the small hole on the bolt head.
*Towel bar and Pull Handle Addendum Due to design changes in the LETET, LESET, ETE, and ESE Series of bypass shower enclosures. There are now two separate types of pull handle and towel bars. The (ASD1) pull handle and the (ASD#T) towel bar are designed for glass with ½” holes. While the (ASD1R) pull handle and (ASD#R) towel bar are designed for glass with 7/8” holes. While ordering replacement parts please specify hole dimension.(1/2” or 7/8”).