Bifold Doors Assembly Instructions
Notes: • Wear Safety Goggles • Dimensions are in inches Millimeters are shown in brackets • Fits normal finished opening height of 801/2 “ • 2-Door and 4-Door Installations below.
Tools Needed: Phillips Screwdriver, Penc il, Drill, Measuring Device, 3/1 6˝ (5mm) Drill Bit, 3/32˝ (2mm) Drill Bit (optional for pilot holes) .
Step 1 - Prepare Track for Mounting Insert components as shown in Figure 2 for 4-Door set or as in Figure 4 for 2-Door set. The Upper Pivot may need to be loosened in order to attach to the track. If so, loosen the screw with a Phillips screwdriver and if necessary loosen the bolt with the included wrench just enough to slide the Upper Pivot onto track .Tighten Upper Pivot with a Philli ps screwdriver as shown in Figure 5.
Step 3- Mount Hinges Lay Pa nels side by side on a flat, clean surface as shown in Figure 7. Push the Pa nels together and mount hi nges in pre- drilled pilot holes. Mount Top/Bottom Hinge as sh own in Figure 8. Mount Center Hinge at center of door as sh own in Figure 9. Note: Only use screws as shown in figures below and use only pre-drilled pilot holes.
Step 4- Fasten Mount Plates Fast en Mount Pl ates as sh own below. Mount plates acco rding to the direction of door swing; right swing or left swing as sh own in Figures 1 0 & 1 1 below. It may be helpfu l to mark the mount plate holes with a penc il and usi ng a 3/32˝ drill bit, drill a 1 ˝ deep pilot hole before insertng screws .N ote: Make sure t he nylon lock ing arm is on the back of the door.
Step 6 - Mount Lower Jamb Pivot U s e a P h i l l i p s s c rew d r ive r t o a d j u s t t h e L ow e r J a m b P i v o t t o t h e p o s i t i o n s h ow i n F i g u re 15 .Mount the Lower Jamb Pivot by placing it directly under the Track on the pivot side as shown in Figures 1 5& 1 6 below. Fasten with 1 EA Long Sc rew in the sl ot first to allow adjust ment up and down to give clearance between Lowe r Jamb Pivot and the bottom of the door as sh own in Figure 17 .
Step 8 Check Operation, Make Adjustments If necessa ry use the Wrench supplied to adjust the bolts in the Upper Pivot and Roller to assu re the BiFold door set is hanging square in the opening. The Lowe r Jamb Pivot can be adjust ed with a Phillips screwdriver. Arrows in Figure 18 below sh ow directions of adjustments .
For 4-Door Installs : Attach each Fascia to the upper corner of the Track by removing the tape backing and pushing against track as shown in Figure 20 . Cut Fascia s if necessary. (Cut with Fascia front up.) Place Fascia Block over the gap at the center of the opening. FIGURE 20 Attach 4-Door Fascia Step 1 0 - Attach The Pull Attach the Pul l to the inside stile of the non- pivoting door panel as shown in Figure 1 .
