Owner Manual

HEAVY

DUTY SQUARE FIRE RIM

Read this manual carefully before using this product and save it for future reference.

  

A Panel 4

T Bolt (1/4" x 5/8") 16

U Washer 16

V Nut 16

X Allen Wrench 1

Y Wrench 1

Z Poker 1

ASSEMBLY

Tools required for assembly included: Allen Wrench (X) and Wrench (Y)

DO NOT FULLY TIGHTEN THE NUTS & BOLTS BEFORE ASSEMBLING THE ENTIRE RIM.

1. Set Panels (A) upright and align the holes on the top and sides of the panels, making sure the lip

on the side of each panel will be on the inside of re rim.

2. Connect the rst 2 panels by hand-tightening 4x Bolts (T), 4x Washers (U), and 4x Nuts (V).

3. Repeat Step 2 until all panels are connected.

4. Tighten all hardware using Allen Wrench (X) and Wrench (Y).

• Do not discard packaging until you have checked that all parts are accounted for.

• Assemble components on a soft, clean surface to avoid scratching or damaging

the finish.

• Keep children away during assembly. This item contains small parts that can

be swallowed by children.

• Children should always be under direct adult supervision around this product.

Purchase Date: / / Order/Customer Reference Number:

If you have any questions, comments or concerns, feel free to contact us by phone, by email, or via our page

Thank you for choosing our Decor. We stand behind our brand and the quality of the items we sell.

Replacement parts or products will be sent at our discretion within the 1-year warranty period. Proof of

purchase, with the date of purchase as well as photos of the merchandise defect, must be provided.

Photos are used to determine the cause of defects and for future quality control.

Page 1 / 2

PAGE 1
Purchase Date: / / Order/Customer Reference Number: Thank you for choosing our Decor. We stand behind our brand and the quality of the items we sell. Replacement parts or products will be sent at our discretion within the 1-year warranty period. Proof of purchase, with the date of purchase as well as photos of the merchandise defect, must be provided. Photos are used to determine the cause of defects and for future quality control.
PAGE 2
CARING FOR YOUR FIRE RIM: Clean Regularly: All fire rims must be cleaned and inspected periodically. The ash produced in fire rims must be cleaned out regularly. Clean Safely: Make sure the fire has completely died down and the metal is completely cool before you remove the ashes. Avoid Accelerants: Never use accelerants to start a fire; this is dangerous and can be damaging the fire rim. Avoid Plastic: Never use any plastic materials in or nearby a fire.