User Manual

62
the back of the base station for about 10 seconds.
When the base station reset completes, the LEDs on the front of the base
station blink amber. When the LEDs stop blinking amber, your base station
reboots. The base station is removed from your Arlo account.
2. When the Power and Internet LEDs both light solid green, tap the Arlo icon on
your mobile device and log in to your Arlo account.
If you are using a computer, enter netgear.com in the address bar of a browser.
3. Click or tap New System Setup.
4. Follow the setup instructions.
If your wire-free cameras were synced to the base station, you might need to sync
the cameras to the base station again. For more information, see Use the Arlo App
to Set Up an Account on page 8.