Use and Care Manual

English 7
preventer, for example,
is permitted.
Use a water filter to avoid potential
damage from dirt in the water supply.
● Garden hose must be at least
5/8 inch (16 mm) in diameter.
● Flow rate of water supply must not
fall below 2 GPM/gallons per minute
(7.6 L/min).
● Flow rate can be determined by
running the water for one minute into
an empty 5-gallon (18.9 liter)
container.
● The water supply temperature must
not exceed 104°F/40°C.
● Never use the pressure washer to
draw in water contaminated with
solvents, e.g. paint thinners,
gasoline, oil, etc.
● Always prevent debris from being
drawn into the unit by using a clean
water source.
This pressure washer is provided with
a ground-fault circuit-interrupter
(GFCI) built into the plug of the power-
supply cord. This device provides
additional protection from the risk of
electric shock. Should replacement of
the plug or cord become necessary,
use only identical replacement parts
that include GFCI protection.
1. If on unpacking the unit, you discover
damage has been caused during
transportation, contact your
distributor.
2. Check to make sure that all contents
of the package are correct and retain
all documentation.
3. Attach the handle into the unit by
snapping the three buttons into place.
4. Install the hose connector to the
water inlet.
5. The inlet filter must always be fitted
inside the water inlet to filter out
sand, limestone and other impurities
as they will damage the pump valves.
Ground Fault Circuit
Interrupter Protection
Assembly Instructions