TDS

Epoxy Polyamide
Satin
2
1 by volume A:B
Chemical Cure
3 hours
66% ± 2% mixed
80% ± 2% mixed
150-200 sq. ft./mixed 2 gallon kit on bare surface.
300-350 sq./ft mixed 2 gallon kit on previously coated
and bare fiberglass/gelcoat surfaces.
280 g/l max (as supplied)
78° F (SETA)
Brush, no thicker than 3/8”
Min 5 mils (7.5 mils wet), Max 8 mils (12.5 mils wet)
2 (product is self-priming)
50°F min/90°F max
16-72 hours. After 72 hours, must sand before applying 2nd coat
Outdoor Pool: 5-7 days before filling. Indoor Pool: 10-14 days
before filling. Use adequate ventilation
VEHICLE TYPE
FINISH
COMPONENTS
MIX RATIO
CURING MECHANISM
POT LIFE
SOLIDS BY VOLUME
SOLIDS BY WEIGHT
COVERAGE
VOC
FLASH POINT
APPLICATION METHOD:
DRY FILM THICKNESS PER COAT
NUMBER OF COATS
APPLICATION TEMP.
RECOAT TIME
DRY TIME
PRODUCT DESCRIPTION
Industrial grade 2-part epoxy high build coating formulated to give maximum protection to your swimming pool. Used by
government and municipalities for coating their pools. High solids formulation helps to hide minor divots and imperfections in
surfaces and will ‘smooth out’ pool surfaces. Satin finish. Self-priming, no primer required. Can be used an economical
alternative to replastering.
Can be applied over most types of epoxy pool coatings in good condition, as well as bare concrete, plaster, gunite and fiberglass.
Can be used in jacuzzi’s and hot tubs. Dries quickly, durable, and resists fading, blistering, chemicals and abrasion
ARMPP2PHBE
2-PART HIGH BUILD EPOXY PAINT
TECHNICAL DATA SHEET
Rev 11/21
Can be applied over most types of epoxy pool coatings
Easy prep with light sanding
No primer required
Satin finish
Can be applied using a ⅜” roller
Multiple coats can be applied
PRODUCT FEATURES
PHYSICAL PROPERTIES
POOL PAINT 2-PART HIGH BUILD EPOXY
Rev 11/21
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this
literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our
control, we can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective
materials. All technical information is subject to change without notice.
PRODUCTS TO BE USED WITH
N/A
BENEFITS
Works on
most pool surfaces
Easy Mix Ratio Roll on Application
ArmorPoxy Inc.
1260 North Ave
Plainfield, NJ 07062
armorpoxy.com
E: [e-mail]
P: 888-755-7361
1:1