Measurement Guide

Easy Up
®
Installation System
Estimating Guide
RC--
maximizes
ceiling height
How to calculate tracks & clips needed:
1 Find your ceiling product on the chart below Example: 12-in × 12-in Tile
2 Calculate the square footage of your room Example: 10-ft wide × 12-ft long room = 120-sq ft
3
Find the track ratio listed for your ceiling product on the
chart
Example: 1.10-lf of Track/sq ft
4 Multiply the square footage by the ratio Example: 120-sq ft × 1.10 = 132-lf
5
Divide the result by 8-ft for total number of tracks
required—Round up if necessary
Example: 132-lf/8-ft = 16.5 (17 Tracks)
(each track = 8-ft length)
6
Find the clip ratio listed for your ceiling product on
the chart
Example: 1.3 Clips/sq ft
7 Multiply the square footage from step 2 by the clip ratio 120-sq ft × 1.3 = 156 Clips
8
Round up if necessary for total number of clips
required
156 Clips
Ceiling Product Track Spacing Ratio of lf of Track/sq ft of room Ratio of Clips/sq ft of room
12-in x 12-in Tile 12-in on center 1.10 1.30
Country Classic
™
Plank 12-in on center 1.10 1.25
WoodHaven
™
Ceiling Planks 24-in on center 0.65 1.20
Easy Elegance
™
Planks 16-in on center 0.80 2.00
lf = linear feet, sq ft = square feet
Notes: Table averages values of room combinations from 10-ft × 10-ft to 30-ft × 30-ft. It is possible that these values could leave you slightly short,
as it is an average. Values assume butting track joints, end to end, with no overlap.