Product Brochure
http://www.floorexpert.com/...stallation_Products_Accessories&KBArticleName=S-750-Premium-Floor-Tile-Adhesive-Product-Information[12/21/2017 1:26:52 PM]
substrates treated with fire-retardant chemicals, fungicides, preservatives, release agents, adhesive removers,
sealers, curing compounds or other incompatible treatments
Installation Procedures
For use with the following Installation Systems:
Commercial Vinyl Composition Tile
Residential Dry Back Vinyl Tile
Use as primer for wood and concrete with self-adhering tile.
INSTALLATION TIPS: Refer to flooring installation system.
Condition area to be installed, adhesive, and tile at 65° F (18° C) or above for 48 hours before and 48
hours after installation.
Subfloor must be smooth, sound, dry, clean, and free of dirt, wax, polish, paint, and all other foreign
matter which may interfere in a good bond, including curing agents and sealers.
Always run a moisture and alkali test over concrete on any grade level or any other substrate over on- or
below-grade concrete. For accurate results, curing agents must be removed in areas where tests will be
run. Calcium Chloride test results should not exceed 5 pounds/1000 sq ft/24 hours, relative humidity in-
situ probe results should not exceed 80%. Alkali readings should be 5 to 9.
Stir any liquid on the surface into the adhesive and full spread using the recommended trowel notching.
When using as a primer, apply a thin film using a smooth edge trowel, brush or roller.
Allow adhesive to set open until dry to the touch, approximately 30 minutes. When dry to the touch, the
adhesive will be tacky with no transfer to fingers.
Install and fit all tile within 6 hours. Working time will vary based on job conditions, substrate, temperature
and humidity.
Most resilient commercial tile does not need to be rolled upon completion of the installation. However,
residential tile and certain specialty tile must be rolled - refer to Tile Installation System for
recommendations.
Remove wet adhesive residue using a clean, white cloth dampened with soapy water. Use mineral spirits
for dried adhesive residue carefully following warnings on container.
Do not wet wash or strip tile for at least five days after installation.
LEED / Environmental
LEED Credits: EQ 4.1
Sustainable Design Information Sheet
LEED Credit Information - Installation Products
Warranty
When Armstrong S-750 is used with a recommended Armstrong floor application, the Armstrong Guaranteed
Installation System warranty applies.
Product Image
Installation Procedures
LEED / Environmental
Warranty
Product Image