Installation Guide

Chapter IV — Installation Systems884.
working time, and may generate excessive heat. Maximum pot life of
the S-240 Epoxy Adhesive is approximately 10 minutes depending on
temperature and atmospheric conditions.
5. Apply S-240 Epoxy Adhesive for only 2 or 3 rows of tile. Working time of
S-240 Epoxy Adhesive is approximately 1 hour.
6. Tile may be placed into the adhesive immediately, but allowing 15 to 20
minutes of open time and fitting border tile tightly will reduce tile shifting
and adhesive oozing. Do not allow the adhesive to dry completely.
7. Install tile with the arrows on the back of the tile pointing in the same
direction.
8. Roll tile in both directions within 1 hour of spreading S-240 Epoxy
Adhesive using a 100-lb. roller. Re-roll 1 hour later in both directions.
Remove adhesive residue from the surface of all the tile immediately
using a clean, white cloth dampened with neutral detergent and water.
Dried S-240 Epoxy Adhesive cannot be removed.
9. Do not work on newly adhered tile except to roll tile. Use a kneeling
board if necessary.
10. Repeat Steps 4 through 9 until the entire area is completed.
11. Do not allow traffic on tile for 24 hours after installation.
12. Flooring should not be exposed to rolling load traffic for at least 72 hours
after installation to allow setting and drying of the adhesive.