Warranty Guide

 Installation defects and installations not using the recommended Armstrong
adhesives.
 Damage caused by abuse such as moving appliances across the floor without
adequate protection. When moving appliances or heavy furniture, lay a plywood
panel on your floor and “walk” the item across it. This protects your floor from
scuffing and tears.
What Is Excluded From These Warranties?
None of our installers, retailers, distributors or employees has authority to alter the
obligations, limitations, disclaimers or exclusions under any of our warranties.
WE EXCLUDE AND WILL NOT BE LIABLE FOR OR PAY INCIDENTAL,
CONSEQUENTIAL OR SPECIAL DAMAGES UNDER OUR WARRANTIES. By this we
mean any loss, expense, or damage other than to the flooring itself that may result from
a defect in the flooring. Our limited warranties constitute the only express warranties for
the product purchased.
TO THE EXTENT PERMITTED BY LAW AND FOR ALL NON-CONSUMER
PRODUCTS, ALL WARRANTIES OTHER THAN OUR LIMITED WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING ANY WARRANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE, ARE DISCLAIMED. IF ANY IMPLIED
WARRANTY ARISES UNDER STATE LAW, ANY AND ALL IMPLIED WARRANTIES
(INCLUDING ANY WARRANTY OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE) ARE LIMITED IN DURATION TO THE DURATION OF THIS
WRITTEN WARRANTY, TO THE EXTENT ALLOWED BY LAW.
SOME JURISDICTIONS DO NOT ALLOW EXCLUSION OR LIMITATIONS OF
INCIDENTAL OR CONSEQUENTIAL DAMAGES OR LIMITATIONS ON HOW LONG
AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATIONS OR EXCLUSIONS
MAY NOT APPLY TO YOU.
THESE WARRANTIES GIVE YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO
HAVE OTHER RIGHTS WHICH VARY FROM JURISDICTION TO JURISDICTION.
Installation requirements
Proper installation plays a key role in the performance of Armstrong floors. For
installation of vinyl tile, these basic guidelines should be followed:
 Store tiles for 48 hours in room where they will be installed. Keep room at a
minimum of 65°F during that time and during installation. After installation,
temperature should not fall below 65°F for the first 48 hours, and not below 55°F
after that.
 If room is heated by radiant coils in the subfloor, the TEMPERATURE OF THE
FLOOR should not exceed 85°F.
 The subfloor must be level, clean, and free of wax, grease, oil or dust.
 If necessary, patch or fill any cracks in the subfloor with Armstrong Patch, or
Armstrong Latex Underlayment.
 Use Armstrong Embossing Leveler to smooth any texture or embossing on the old
floor. Install over smooth, well-bonded resilient floors or over dry concrete and wood
floors with a plywood overlay.