Installation Sheet

1. Screw the mounting screw (#6) into the mounting bracket (#4). Mount the mounting

bracket (#4) to the outlet box (#3). Make sure the heads of the mounting screw (#6)

are facing outside when the mounting bracket (#4) is attached to the outlet box (#3)

2. Connect the ground wire from the fixture to the ground wire from the outlet ox (#3).

Connect the white wire from the fixture to the white wire (neutral wire) from the outlet

box (#3). Connect the black wire from the fixture to the black wire (live wire) of the

outlet box (#3). Cover the connections using the wire connectors (#2). Wrap the wire

connectors with electrical tape for a more secure connection. Position the wires back

inside the outlet box (#3). Note: If you have electrical questions, consult your local

licensed electrician.

3. Place the canopy (#1) over the outlet box (#3), Allow the heads of the outlet box

screws (#5) to come out through the large end of the keyholes of the canopy (#1).

Twist the canopy (#1) until the heads of the outlet box screws (#5) slide into the

narrow ends of the keyholes. Screw the outlet box screws (#5) to secure the canopy

(#1).

4. Before completing installation, please adjust the lamp body (#8) height by pulling

the JoJo Bar (#7) downward or upward till you find what is the best position and

brightness.

5. Installation is complete, Turn on the power at the circuit breaker of the fuse box.

Turn the light switch on to activate the fixture.

Quattro Dimming System:

This Fixture is equipped with an integral dimming system. Only an On / Off switch is

required to regulate the light level of the fixture. Toggle the switch once, and it will go

to full brightness, the second toggle will set it at 50%, the third toggle at 20%, then

off.

4. Mounting Bracket

COLUMBUS

378490607

ASSEMBLY INSTRUCTIONS

Mounting Instructions:

Assembly Instructions:

customerservice@arnsberg.com