Instructions / Assembly

27
You will need for this page:
Step 9: Continued
27H
Install Track Support.
Working with one Gable at a time,
attach the Gables to the top Rear
Frame with Small Screws. The
Gable should be attached using the row of
holes closest to the outside of the building. Do
not insert screws into the two holes closest to
where the Gables join. These will be used to
attach the Track Support later.
2
To secure Gables together, position
the Gable Brace as shown below and
insert a single Small Bolt and Nut
through the second hole from the bottom only.
3
4
Position Track Supports as shown.
Secure Track Supports to Gable
using one Small Bolt and Nut.
Secure to Rear Frame using two Small
Screws.
Gable must fi t UNDER Side Wall Angle at corner.
Gable Brace
1
9009
(QTY: 2)
Track Sup.
2
(QTY: 16)
Leave two holes open on each side of the Gable peak to attach Track Support.
Attach Gable to holes closest
to the Outside of the building.
8576
8577
6228
SB
SBSS
6228
Attach Brace with bolt thru
second hole from bottom only.
SB
9009
10’x10’ (3,0 m x 3,1 m)
building shown.
Gable
Rear Wall
Outside
Inside
10629
R