Instructions / Assembly

44
Step 13: Continued
You will need for this page:
Slide Bolt
1
66779
44H
Hanging the Doors:
After the doors have been assembled, install hinges on one door
using fl athead screws and nuts. Use the image to the left as a guide
to proper hinge position. Next, position one door in the doorway of
the building and secure the hinges, from top to bottom, to the door
jamb, but do NOT fully tighten. With all hinges in place, hold the
door in alignment and slowly tighten the bolts on the door jamb side
of the hinge. Repeat to hang the other door.
Swing the doors carefully to check alignment. If doors are misaligned,
slightly loosen the bolts on the door jamb side of the hinge and
realign the door. Fully tighten when done.
Slide Latch Plate into position on the left Door.
Next, position the Slide Bolt on the face of the
Door and secure with Large Bolts and two
Square Nuts on each Bolt. Position the Door Handle on
the face of the Left Door and secure with Large Bolts and
Square Nuts. This completes the Left Door assembly.
8
Slide end of Latch Plate behind Door Brace.
Slide Latch Plate into position on the right Door.
Next, position the Door Handle on the face of the
Door and secure with Large Bolts and Square
Nuts. This completes the Right Door assembly.
9
IMPORTANT: Once the building is fully assembled, measure
across the door opening and check that it is 98 1/4” (249,6 cm).
If it is not, move the front walls in or out slightly to match this
dimension. This must be done BEFORE anchoring.
Latch Plate
2
10651
FS
FS
Hinge
6
66609
Door Handle
2
66782
(QTY: 36)
(QTY: 8) (QTY: 4)
LB LB
FS
Right Door
Left Door
Outside
Outside