Installation Guide

3
EN
WARNING:
Risk of electrical shock.
Turn off breaker at the panel.
Switch off the main electrical
supply from the fuse box/circuit
breaker before installing the unit
or doing any maintenance.
Do not use outdoors.
IMPORTANT SAFETY
INSTRUCTIONS
We recommend that this product be
installed by a certified electrician.
In some states or provinces, it is
a legal requirement for this type
of product to be installed by a
certified electrician, according to
the electrical and building codes
effective in the region where the
unit is used.
The installer and/or user must
read, understand and follow these
instructions before installing the
product. This product must be
properly installed before it is used.
If instructions are not followed,
the manufacturer will not be held
responsible for any problems or
product malfunction. Failure to
follow installation and/or operating
instructions voids the warranty.
Switch off the main electrical
supply from the fuse box/circuit
breaker before installing the unit
or doing any maintenance.
FR
AVERTISSEMENT :
Risque de choc électrique.
Éteindre le disjoncteur sur
le panneau électrique.
Il est important de couper
l’alimentation électrique du
disjoncteur avant de procéder à
l’installation ou à l’entretien.
Ne pas utiliser à l’exterieur
INSTRUCTIONS DE SÉCURITÉ
IMPORTANTES
Nous recommandons que
ce produit soit installé par
un électricien certifié. Dans
certains états ou provinces, il est
légalement requis que ce type
de produit soit installé par un
électricien certifié conformément
aux codes de l’électricité et du
bâtiment en vigueur. Avant
l’installation de ce produit,
l’utilisateur et/ou l’installateur doit
avoir lu et compris ces instructions.
Cet appareil doit être installé
convenablement avant usage.
Si ces instructions ne sont pas
respectées, le fabricant ne
pourra être tenu responsable
d’aucun problème ou de
dysfonctionnement du produit.
Le non-respect des instructions
d’installation et/ou d’utilisation
annulera la garantie en vigueur.
ES
ADVERTENCIA:
Riesgo de descarga eléctrica.
Desconectar la corriente
eléctrica del panel
(disyuntor).
En la caja de circuitos/disyuntor
antes de instalar esta unidad o
realizar tareas de mantenimiento
en ella. No uso en exteriores.
INSTRUCCIONES DE
SEGURIDAD IMPORTANTES
El instalador o usuario deben leer
detenidamente las instrucciones
antes de instalar el producto y
seguirlas fielmente. El producto
debe estar correctamente instalado
antes de su instalación.
Si no se siguen las instrucciones,
el fabricante no se hará
responsable de problemas o de
un funcionamiento incorrecto
del producto. Si no se siguen las
instrucciones de instalación o de
uso, se anulará la garantía.
Le recomendamos que el producto
sea instalado por un electricista
certificado. En algunos estados
o provincias, se requiere por ley
que este tipo de producto sea
conectado por un electricista
certificado siguiendo los códigos
eléctricos y arquitectónicos de la
región.