Instructions / Assembly

4
INSTRUCTION MANUAL / MANUEL D’INSTRUCTIONS / MANUAL DE INSTRUCCIONES
EN
CAUTION
If using a dimmer, it must
be LED compatible.
IMPORTANT
The installer and/or user must
read, understand and follow these
instructions before installing the
product. This product must be
properly installed before it is used.
If instructions are not followed,
the manufacturer will not be held
responsible for any problems or
product malfunction. Failure to
follow installation and/or operating
instructions voids the warranty.
We recommend that this product be
installed by a certified electrician.
In some states or provinces, it is
a legal requirement for this type
of product to be installed by a
certified electrician, according to
the electrical and building codes
effective in the region where the
unit is used.
Switch off the main electrical
supply from the fuse box/circuit
breaker before installing the unit or
doing any maintenance.
FR
ATTENTION
Si vous utilisez un gradateur,
celui-ci doit être compatible
avec les lumières à DEL.
IMPORTANT
Avant l’installation de ce produit,
l’utilisateur et/ou l’installateur doit
avoir lu et compris ces instructions.
Cet appareil doit être installé
convenablement avant usage.
Si ces instructions ne sont pas
respectées, le fabricant ne pourra
être tenu responsable d’aucun
problème ou dysfonctionnement
du produit. Le non-respect des
instructions d’installation et/ou
d’utilisation annulera la garantie
en vigueur.
Nous recommandons que
ce produit soit installé par
un électricien certifié. Dans
certains États ou provinces, il est
légalement requis que ce type
de produit soit installé par un
électricien certifié conformément
aux codes de l’électricité et du
bâtiment en vigueur.
Il est important de couper
l’alimentation électrique du
disjoncteur avant de procéder à
l’installation ou à l’entretien.
ES
ATENCIÓN
Si usted utiliza un regulador,
éste debe ser compatible con
lámparas LED.
IMPORTANTE
El instalador o usuario deben leer
detenidamente las instrucciones
antes de instalar el producto y
seguirlas fielmente. El producto
debe estar correctamente
instalado antes de su instalación.
Si no se siguen las instrucciones,
el fabricante no se hará
responsable de problemas o de
un funcionamiento incorrecto
del producto. Si no se siguen las
instrucciones de instalación o de
uso, se anulará la garantía.
Le recomendamos que el producto
sea instalado por un electricista
certificado. En algunos estados
o provincias, se requiere por ley
que este tipo de producto sea
conectado por un electricista
certificado siguiendo los códigos
eléctricos y arquitectónicos de la
región.
Desconecte la instalación eléctrica
en la caja de circuitos/disyuntor
antes de instalar esta unidad o
realizar tareas de mantenimiento
en ella.