Operating instructions

33.
1. Raise the presser foot with the hand lifter lever.
2. Insert the bobbin onto the bobbin winder spindle.
3. Thread the winder in the order illustrated and wind the
thread four or five turns onto the bobbin.
4. Push the bobbin winder trip latch (A) down. When the
machine is operated the spindle will turn and start to wind
the bobbin.
5. When the bobbin is fully wound, the trip latch will
disengage and the spindle will stop.
To adjust the quantity of thread on the bobbin:
1. Loosen the adjusting screw and nut number (B) and (C.)
and turn the screw counterclockwise to decrease the
amount of thread on the bobbin and clockwise to increase
the quantity of thread wound onto the bobbin.
2. Tighten the locking nut after adjusting for the correct
amount of thread to be wound onto each bobbin.
If the bobbin is not winding evenly, move the thread guide (D)
either left or right to compensate.
Several Bobbins can be wound while the machine is stitching.
Winding the Bobbin on a TORO-4000 R
TORO-3000 and TORO-3200 Bobbin Winder Instructions:
1. Place the bobbin on the spindle. Align the small pin on the spindle
with the hole or slot in the bobbin.
2. Insert the thread into the eye above the bobbin winder tension.
3. Pull the thread between the two tension discs in a clockwise fashion.
4. Continue pulling the thread over to the bobbin and place the thread through the small hole
on the right side of the bobbin and thread it from the inside of the bobbin to the outside of the bobbin.
Leave about 3 or 4 inches outside the bobbin. Trim the excess after the bobbin is wound.
5. Push the Latch up against the center of the bobbin.
6. Operate the machine and the bobbin will begin to fill.
Several bobbins can be wound while the machine is in operation.
If the thread is wound too loosely, tighten the tension nut, if too tight, loosen the nut.
1.