Operating instructions

36.
See Page 6 for Another View of
Correct Threading Instructions
a
r
t
i
s
a
n
u
A
B
C
H
G
F
E
D
Insert the thread through the upper
wire thread guide (A), then around the
top tension (auxiliary tension) in a
clockwise rotation between the 2 disks,
one revolution and back up to the same
wire thread guide (A).
Bring the thread down and insert it
into the main tension thread guide (B)
as shown. Then wind your thread in a
counter-clockwise rotation 2 full revo-
lutions around the main tension rotary
disk, and then back up through the
same thread guide (B) a second time.
Next pass the thread through the
hole in the “check spring” (C). Then
pull the thread up and pass it through
the hole in the take-up lever (D) from
the left side to right hand side. The
lever moves up and down. Then pass the
thread down and through the left side
of lower middle thread guide (E).
Next pass the thread through the
lower wire thread guide (F) and
through the thread guide hole in the
bottom of the needle bar (G).
Lastly pass the thread through the
eye of the needle (H) from the left to
to right side towards the hand wheel.
Always leave about 6 to 10 inches of
thread beyond the needle.
Remember to hold the bobbin and
needle threads tightly while stitching
the first few stitches.
C
B
artisanu TORO-3000, 3200 and 4000 THREADING