Operating instructions

SWITCH OFF THE MOTOR BEFORE REMOVING

OR INSERTING A NEEDLE

Artisan recommends that you use only “SCHMETZ” brand Needles.

For Leather use size; 794 D, 794 S, 794 LR

For Canvas, Nylon and Fabrics use size: 794

1. Turn the hand wheel counter-clockwise and raise the needle bar

to its highest position.

2. Loosen the needle set screw

(1) remove the old needle and

insert a new needle #2 into the needle bar. Push it up into

the hole as far as it will go.

3. Remember to locate the needle scarf

(A) towards the hand

wheel and the long groove of the needle to the left side.

4. Securely tighten the needle set screw

(1).

See Page 31 for

bobbin winding instructions

for the

TORO-3000 and TORO-4000 R machines.

of a TORO-4000 P

3. Depressing the retaining latch #(1) will open the bobbin case.

4. Remove the bobbin being careful to leave the light weight beehive

shaped bobbin push spring inside the bobbin case.

1. Push the bobbin

(3) onto the bobbin winder shaft until it seats.

2. As pictured, thread the sewing thread through the thread guide

(2) and around the tension post counter-clockwise, once, then

back out through the front thread guide.

3. Wind the thread around the bobbin several times and push the

lever

(5) to the left to engage the bobbin winder.

As you are sewing the bobbin will begin to fill,

when the bobbin is filled, the latch will disengage

and the bobbin spindle and bobbin will stop.

4. Loosen screw

(6) and adjust the bracket on lever

(5) to

adjust the fill amount on the bobbin.

1. Turn the handwheel counter-clockwise until the needle reaches

its lowest position.

2. Place your open left hand under the Shuttle area to catch the bobbin.